Location Mike P. Location Georgia Occupation Electrical Monke. Location San Francisco, CA. To be clear - you could put a ,sq' homes recepts all on one single 15a circuit - well outside of the SA circ's - it's all a matter of prefferance. Me: it all depends - I look at each differently Volta Senior Member. Location Columbus, Ohio. Buck Parrish Senior Member. Most lamp and cord appliance's. Thier cords are only rated for 7 amps. So a 15 amp circuit breaker would be safer then a Buck Parrish said:.
Not at exactly 15 Amps. The breakers on a house and most similar breakers have a fairly complex trip characteristic. For one thing they always allow more as they are guaranteed to pass the rated current. For another thing they have dual trip mechanisms, both magnetic and thermal.
Standard amp receptacles are suitable for typical household appliances, lamps and other accessories. Improve this question. Scott Scott 1 1 1 bronze badge. Add a comment. Active Oldest Votes. Improve this answer. I like keeping the lights on separate circuits also but it is bad practice to change wire size.
If you want to only run 1 circuit run everything in 12 and use a 20 amp breaker. EdBeal bad practice, but allowed nonetheless. I edited to emphasize using 12 throughout is the preferred method. Many newer homes and some older large homes have a or amp service panel. This type of service might be required in a home that uses a lot of large electrical appliances and includes heating and air conditioning equipment.
Upgrading to a larger service panel can give you more flexibility to use more circuits without worrying about overloading the system. A amp service might be needed for larger homes with equipment that demands a lot of energy, such as a backyard hot tub or a home theater system. A service panel should be located where adults can get to it easily but children can't. Any exposed cables leading to it should be firmly attached to the wall and clamped tightly to knockout holes in the panel.
If a gauge wire is connected to a amp circuit breaker or fuse, replace the breaker or fuse with one that is 15 amps to prevent the wire from overheating. In most cases, a amp fuse or breaker should connect to a gauge wire; a amp fuse or breaker should connect to a gauge wire.
Wires should run in a fairly orderly way around the perimeter of the panel. If you find a hopeless tangle, call in an electrician for an evaluation. You should also call in a pro if you find melted or nicked wire insulation, any signs of fire, or extensive rust.
In an older home, there's a good chance that new wiring has been added to a service panel. It might have been done by a pro, but it could be amateur work too, so check all the connections to ensure safety. By Jessica Bennett Updated October 01, Each product we feature has been independently selected and reviewed by our editorial team. If you make a purchase using the links included, we may earn commission.
Save Pin FB More.
0コメント